期刊论文

中文

机床与液压

1001-3881

2009

37

1

148-150+114

10.3969/j.issn.1001-3881.2009.01.052

中南林业科技大学青年基金资助项目（编号:2006035B）；

本校为第一机构

蜗杆传动是机械设计中较为常用的机构,通常采用强度校核的方法进行设计,所做出的设计是符合传动条件的,但往往不是最优化的设计,本文作者以三维软件Pro/e为设计平台,采用VC+ +6.0为设计界面,首先利用Pro/e的程序和尺寸驱动功能生成三维模型,然后输入零件设计信息,调用Matlab7.0完成优化设计与计算,利用程序驱动Pro/e再生完成优化设计以后的蜗轮和蜗杆的三维模型,最后得到零件的二维平面图.

The design of worm drive usually uses the method of intensity emendation, the design is fit for the condition of design, but it＇ s not the most optimized. With the three-dimension software Pro/e as a design platform, the interface was designed by software VC ＋＋ 6.0, the three-dimension models was created by the dimension-drive and program-drive function of the software Pro/e. By inputting the design information, the calculation for optimized design was carried out by software Matlab7. 0, the three-dimension model of the worm and worm wheel a...